Page 13 - Exitflex
P. 13

Airless Flat tips Product specification sheet Airless Flat tips

for automatic, robotic and manual coating
applications in all industries
All Exitflex flat tips integrate high quality tungsten Our standard airless flat tips programme consists of:
carbide inserts, which provide maximum erosion
resistance for high-pressure spraying. Despite their The Standard Industrial
extreme hardness, Tungsten carbide tips do wear. Reference : 63-505
Replace them before its costs a great deal of money stainless steel body
in labor and material! All tips are laser-marked. h h = 11mm , ø = 15mm
Customised marking may be applied on demand.
The Superfine
Reference : 63-509
stainless steel body
h h = 15mm , ø = 15mm

The Line Marking
Reference : 63-507
Spray angles and pattern widths quoted are as
stainless steel body
manufactured and tested on water. Spray widths
h h = 11mm , ø = 15mm
can vary and depend upon viscosity, solids content
and pressure employed. To determine a new flow ø
rate (Q2) at a new working pressure (P2),
The Contractor I
use the following formula, knowing that P1 = 100 Bar
Reference : 63-501
carbon steel, black zinc plated body
The following equivalent orifice size ranges are h = 8.7mm , ø = 15mm
suggested for the material listed: ø
Stains and lacquers: 0.006in to 0.013in
The Contractor II
Oil based paints 0.013in to 0.015in Reference : 63-513
Latex emultions 0.017in to 0.021in carbon steel, zinc plated body
h h = 10.50mm , ø = 15mm
Heavy paints, latex 0.023in to 0.029in
Block fillers, epoxies 0.029in to 0.061in
Remember - Lower viscosity materials such as
Other materials, shapes and sizes on request.
lacquers means smaller orifice sizes and heavier
viscosity coatings such as oil-based paints means
larger orifice sizes.
   8   9   10   11   12   13   14   15   16   17   18